Patch-ID# 108620-04
Keywords: Netra t1 Standalone User PROM 
Synopsis: Hardware/PROM: Netra t1 Standalone User PROM Update
Date: Feb/10/00

Solaris Release: 2.6 7

SunOS release: 5.6 5.7

Unbundled Product: Hardware/PROM

    NOTE: This utility is *not* OS-dependent.  The list of releases shown
          under the "Solaris Release" and "SunOS Release" sections may not 
          be complete: The absence of a valid Solaris Release or SunOS  
          Release from the lists above does not preclude the installation 
          of this patch against the hardware.
 
Unbundled Release: 1.0

Topic: Hardware/PROM: Netra t1 Standalone User PROM Update

BugId's fixed with this patch: 4281143 4304776 4306969 4307608

Changes incorporated in this version: 4307608

Relevant Architectures: sparc
    NOTE: sun4u Netra t1 only

Patches accumulated and obsoleted by this patch: 

Patches which conflict with this patch: 

Patches required with this patch: 

Obsoleted by:

Files included with this patch:

Update.to.netrat1.userprom@OS

Problem Description:

4281143	 tty-control dropin on Netra t1 causes console to hang after break
4304776	 OBP 'cdrom' alias is wrong if external SCSI cdrom attached
4306969	 The README file for patch T108620-02 doesn't have a list of files included
4307608	 Patch T108620-03 incorrectly delivers the README file for T108620-02


Patch Installation Instructions:
--------------------------------
Copy the script provided with this patch, Update.to.netrat1.userprom@OS, to the 
system to be upgraded. Log onto that system as root and run the script. You
will see the following output:
 
WARNING: This Program will write a new USERPROM image.
         Are you sure you want to do this?
 
Enter 'C' to Continue installation or 'T' to Terminate
C
Stripping bundled file: done
Decoding and untaring: done
Verifying checksums: done
Installing uflash driver file: done
 
WARNING:  Updating User PROM with new system firmware in progress...
          It may take a few minutes.
 ******   DO NOT INTERRUPT OR POWER-DOWN THE SYSTEM   *******
 
userflash1 programmed successfully

****************************************************************
*   NOTE: updated Firmware takes effect after next reboot or   *
*   Power cycle of the system.                                 *
*   If there is any configuration support to become effective, *
*   you have to use -r with your boot command                  *
****************************************************************

Then reboot your system.

This image will replace the whole of the current userflash image with the image
provided as part of the script. Do not run this script if you have added 
custom dropins to your userflash image.

   
Special Install Instructions: 
----------------------------- 

**************************************************************************
**************************************************************************
**WARNING:****WARNING:****WARNING:****WARNING:****WARNING:****WARNING:**

*  PLEASE READ THE INSTRUCTIONS CAREFULLY AND ENTIRELY.  PLEASE FOLLOW THE
   INSTRUCTIONS EXACTLY AS THEY ARE STATED.
   
*  FAILURE TO FOLLOW INSTRUCTIONS COULD EITHER RESULT IN A DEFECTIVE BOARD OR
   UNSUCCESSFUL FLASH PROM UPDATE.
   
*  THIS IS NOT A STANDARD PATCH in that it does not use the installpatch
   and backoutpatch scripts.
   
*  THIS PATCH CANNOT BE INSTALLED ON AN ONLINE OPERATING SYSTEM BECAUSE
   THE INSTALL INSTRUCTIONS REQUIRES THAT THE SYSTEM BE BROUGHT DOWN.
   BE SURE TO SCHEDULE DOWN TIME TO INSTALL THIS PATCH.
    
**WARNING:****WARNING:****WARNING:****WARNING:****WARNING:****WARNING:**
**************************************************************************
**************************************************************************