Patch-ID# 114632-06
Keywords: state_arq_done arq disabled connect removed disk scsi reset
Synopsis: SunOS 5.8: FUJITSU ULTRA LVD SCSI Host Bus Adapter Driver 1.0
Date: Jun/18/2004


Install Requirements: Reboot after installation                      
                      See Special Install Instructions                      
                      
Solaris Release: 8

SunOS Release: 5.8

Unbundled Product: 

Unbundled Release: 

Xref: 

Topic: SunOS 5.8: FUJITSU ULTRA LVD SCSI Host Bus Adapter Driver 1.0

Relevant Architectures: sparc.sun4us

BugId's fixed with this patch: 4817865 4817871 4817872 4817874 4817875 4817876 4817877 4817880 4817891 4817898 4837781 4837785 4837786 4837787 4837788 4837789 4917774 4917776 4917778 4951668 5006444 5048561 5048567

Changes incorporated in this version: 5048561 5048567

Patches accumulated and obsoleted by this patch: 

Patches which conflict with this patch: 

Patches required with this patch: 

Obsoleted by: 

Files included with this patch: 

/platform/sun4us/kernel/drv/fjulsa
/platform/sun4us/kernel/drv/sparcv9/fjulsa

Problem Description:

5048561 STATE_ARQ_DONE is notified even if ARQ is disabled.
5048567 When trying to connect to a removed disk device, SCSI Reset is issued.
 
(from 114632-05)
 
5006444 Multi-initiator support.
 
(from 114632-04)
 
4951668 Panic if DR/PHP of U320 card is performed twice.
 
(from 114632-03)
 
4917774 Abnormal state of the SCSI controller may be notified under restoration processing after command timeout detection.
4917776 When reset is issued in the restoration processing after SCSI bus error detection, reset processing may carry out an abnormal end.
4917778 Transfer speed of SCSI bus may become slow while booting.
 
(from 114632-02)
 
4837781 Panic may occur if U320 driver detects abnormality on the SCSI bus while booting.
4837785 resources for U320 controller LSI decrease.
4837786 Improvement of transfer rate change procedure executed when U320 driver detects abnormality on the SCSI bus.
4837787 SCSI ID of the initiators overlaps in the multi initiator environment.
4837788 U320 driver cannot control the tape library device.
4837789 Improvement of amount of acquired resource for firmware download.
 
(from 114632-01)
 
4817865 U320 driver detects command timeout.
4817871 U320 driver detects SCSI protocol error in rebooting after packetizedmode was established.
4817872 A performance improvement of read.
4817874 After hot swapping of hardware, U320 driver sets proper transfer rate of that device.
4817875 Release Auto Request Sense ON/OFF control.
4817876 show 'loginfo' in /var/adm/messages.
4817877 A handling improvement in detection of command timeout.
4817880 A handling improvement in detection of Invalid SGL.
4817891 Panic in ulsaintr() if hardware interrupt of the SCSI chip occurred in the U320 driver's attach failure.
4817898 U320 driver's attach fails without retry, if the SCSI chip replied BUSY status in that initialize.

Patch Installation Instructions:
--------------------------------
For Solaris 8 release, refer to the man pages for instructions on
using 'patchadd' and 'patchrm' scripts provided with Solaris.
Any other special or non-generic installation instructions should be
described below as special instructions.  The following example
installs a patch to a standalone machine:
 
        example# patchadd /var/spool/patch/114632-06
 
The following example removes a patch from a standalone system:
 
        example# patchrm 114632-06
 
For additional examples please see the appropriate man pages.

Special Install Instructions:
-----------------------------
 
Reboot the system after patch installation.
The fix(es) included in the patch will not take effect until after
the system has been rebooted.
 
If possible, perform patch installation in single user mode.
If this can not be done, we recommend having the system in as
quiet a state as possible: no users logged on, no user jobs
running

README -- Last modified date:  Friday, June 18, 2004